Local Anesthetic Solutions for Continuous Infusion



Local Anesthetic Solutions for Continuous Infusion


Andrea Casati



Different local anesthetic solutions, including lidocaine, bupivacaine, ropivacaine, and more recently levobupivacaine, have been used for continuous peripheral nerve blocks. When considering local anesthetics, their concentrations, and their mode of administration for continuous peripheral nerve block techniques, it is important to differentiate between the need for surgical anesthesia and maintenance of the block through a perineural catheter. The ideal local anesthetic for clinicians should provide a fast and reliable onset time of both sensory and motor blocks, a long duration of analgesia with maximum differentiation between sensory and motor block in the postoperative period through a continuous or patient-controlled perineural infusion, and the safest profile from a toxicological point of view due to the large infusions for long periods of time leading to a consistent risk of accumulation. Although such an “ideal” local anesthetic is not available on the market, we usually obtain good results with using different local anesthetic solutions used at different concentrations for surgery and postoperative analgesia.


Anesthetic Blocks

The choice of the anesthetic solution, its concentration, and total dose administered must be tailored to the individual patient’s requirement to minimize the onset time and the risk for overdosage. When a catheter is placed close to the nerve, we do not have the problem of prolonging the effects of initial injection, thus we can select a short-onset, intermediate-duration anesthetic solution, such as mepivacaine or lidocaine in concentrations ranging between 1.5% and 2.0%, for the initial bolus. Some authors recommend the use of a combination of anesthetic solutions with different pharmacokinetic properties. The most frequent of these mixtures is a combination of two local anesthetics, one with a short onset and one with a long onset, such as a combination of mepivacaine with either bupivacaine, ropivacaine, or levobupivacaine. The rationale for using these mixtures is to achieve a compromise between the onset of the shorter-acting drug and the duration of the longer-acting agent. However, it must be considered that diluting the two local anesthetics actually reduces the drive of diffusion of each agent into the nerves by reducing the final concentration of each agent. Moreover, it has been reported that when two different local anesthetics are mixed, there is a competitive binding of the two different agents to the
protein carriers, and the free concentration of the more toxic local anesthetic is similar to that produced by using it alone in a volume similar to the volume actually injected.








Table 25-1. Concentrations, Suggested Doses, and Block Characteristics for Peripheral Nerve Blocks with the Local Anesthetic Agents Discussed












































  Concentration (%) Onset Duration (h) Maximum Dose (mg) pH
Lidocaine 1.5–2 Fast 1–2 300–500 + epinephrine 6.5
Mepivacaine 1.5–2 Fast 2–3 500–600 + epinephrine 4.5
Bupivacaine 0.5 Slow 4–12 150–225 + epinephrine 4.5–6
Ropivacaine 0.5–0.75 Slow 2–6 225–300 4–6
Levobupivacaine 0.5 Slow 4–12 150 4–6

The volumes and doses of local anesthetics will depend on the type of surgery (e.g., single block or a combination of different blocks, such as for the lower limb) as well as on whether light general anesthesia is used during surgery. Accordingly, the maximum doses suggested for each anesthetic drug must always be considered (Table 25-1).


Analgesic Blocks

From a theoretical standpoint, it is possible to use either a short-onset and short-duration local anesthetic or a long-acting one also for continuous postoperative infusion. The use of a short-acting anesthetic, such as lidocaine or mepivacaine, is mainly based on the reduced toxicity potential as compared with more potent and lipid-soluble agents. Moreover, short-acting agents also have the theoretical potential for allowing a fast recovery of sensory and motor function after the infusion is stopped, to enable quick and easy neurologic evaluation. The main disadvantage of shorter-acting agents is that they have been demonstrated to be less effective in providing a good differentiation between sensory and motor blocks. Evaluating the use of either 0.2% ropivacaine or 1% lidocaine for continuous interscalene analgesia after open shoulder surgery, it has been reported that both agents provide a similarly adequate analgesia, but a more efficient recovery of motor function was observed in patients receiving 0.2% ropivacaine. This finding is similar to that previously reported with epidural blockade, and can be explained with the different pKa of the two drugs. For this reason, most authors prefer to use long-acting local anesthetics (e.g., bupivacaine, ropivacaine, or levobupivacaine) for continuous perineural infusions.

Only gold members can continue reading. Log In or Register to continue

Jun 19, 2016 | Posted by in PAIN MEDICINE | Comments Off on Local Anesthetic Solutions for Continuous Infusion

Full access? Get Clinical Tree

Get Clinical Tree app for offline access