Facet Joint Interventions: Intra-Articular Injections, Medial Branch Blocks, and Radiofrequency Ablations


CHAPTER 23






Facet Joint Interventions: Intra-Articular Injections, Medial Branch Blocks, and Radiofrequency Ablations







Vikram B. Patel and Sukdeb Datta


INTRODUCTION


•   The prevalence of persistent low back pain secondary to involvement of lumbosacral facet joints has been described in controlled studies as varying from 15% to 45% based on types of populations and setting studies. Lumbar facet joint interventions are used to diagnose as well as treat facet joint–related pain.


•   Prevalence of thoracic facet joint pain has been shown to be 34% to 48% in patients with chronic thoracic back pain.


•   Prevalence of cervical facet joint pain has been shown to be 36% to 67% in patients with chronic neck pain.


INTRA-ARTICULAR FACET JOINT INJECTIONS AND MEDIAL BRANCH BLOCKS


Indications


Common indications for diagnostic facet joint interventions include the following:


•   Lumbar spine


     Image   Traumatic or arthritic nonradicular low back pain.


     Image   Patients can experience pain radiating in to the buttock but rarely radiating beyond the level of the knee.


     Image   Pain on palpation is worse with extension of the lumbar spine and rotation or twisting of spine.


•   Thoracic spine


     Image   Traumatic or arthritic nonradicular upper back or posterior chest wall pain.


     Image   Typically the patient experiences pain on palpation and extension and rotation or twisting of thoracic spine.


•   Cervical spine


     Image   Traumatic or arthritic neck pain, suboccipital headache, persistent and disabling axial neck and/or upper thoracic pain or suspected cervicogenic headache


     Image   Typically pain and/or headache with neck movements in flexion, extension, and rotations


•   Duration of pain of at least 3 months


•   Average pain level of >5 on a scale of 0 to 10


•   Intermittent or continuous pain causing functional disability


•   Failure to respond to more conservative management including physical therapy modalities with exercises and nonsteroidal anti-inflammatory agents


•   Lack of evidence either for discogenic or sacroiliac joint pain


•   Lack of disk herniation or evidence of radiculitis


CONTRAINDICATIONS


Common contraindications for facet joint interventions include the following:


•   Suspected or proven discogenic, sacroiliac joint or myofascial pain in case of lumbar facet interventions


•   Allergies to drugs being considered for the procedure


•   Inability of patient to understand consent, nature of the procedure, needle placement, or sedation


•   Localized or generalized infection


•   Anticoagulation therapy


•   Nonaspirin combination antiplatelet therapy


•   Pregnancy


•   Bleeding diathesis


•   Needle phobia


•   Psychogenic pain


RELEVANT ANATOMY


Lumbar Spine


•   Facet joints (Figure 23-1)


Image


Figure 23-1. Lumbar spine and facet joints. Note the varying angles of the facets from top to bottom.


     Image   Lumbar facet joints are formed by the articulation of the inferior articular process of the superior lumbar vertebra with the superior articular process of the inferior vertebra.


     Image   The lumbar joints exhibit features of typical synovial joints.


     Image   The articular facets are covered by articular cartilage, and the synovial membrane bridges the margins of the articular cartilage of the two facets in each joint.


     Image   Surrounding the synovial membrane is a joint capsule that attaches to the articular process, a short distance beyond the margins of the articular cartilage.


•   Ligaments


     Image   Ligaments connect spinous process, lamina, and bodies of the adjacent vertebrae.


     Image   Anterior and posterior longitudinal ligaments help stabilize the joints.


     Image   The articular capsule surrounds facets and allows gliding motions.


     Image   In the lumbar spine, L4-L5 permits most flexion.


     Image   The anterior longitudinal ligament attaches to the anterior bodies and the intervertebral disk. It is strong and prevents hyperextension.


     Image   The posterior longitudinal ligaments attaches to the posterior aspect of the vertebral bodies and intervertebral disks. It is weaker than the anterior longitudinal ligament and permits hyperflexion.


     Image   Ligamentum flavum connects adjacent laminae of vertebrae and limits flexion. Interspinous ligaments connect the spinous processes. These are weak ligaments. Intertransverse ligaments connect the transverse process and are also weak ligaments.


•   Innervation (Figure 23-2D)


Image


Figure 23-2. (A-E) Cervical, thoracic, and lumbar medial branches.


     Image   The capsules of the lumbar facet joints are richly innervated with encapsulated and unencapsulated free nerve endings.


     Image   Lumbar facet joints are appropriately equipped with sensory apparatus to transmit nociceptive and proprioceptive information.


     Image   Each lumbar facet joint has dual innervations being supplied by two medial branches of dorsal rami (Figure 23-2D).


Image


Figure 23-3. Thoracic facet joints: Note the slanted angles at the middle levels and compare with the upper and lower facets. The interspinous opening for epidural access is minimal in the mid thoracic levels where the angles of the facets are most slanted.


     Image   The medial brunches of the L1-L4 dorsal rami have a constant and similar course.


     Image   Each nerve emerges from its intervertebral foramen and enters the posterior compartment of the back by coursing around the neck of the superior articular process.


     Image   Hugging the neck of the superior articular process, the medial branch passes caudally and slightly dorsally covered by mamillo-accessory ligament, hooking medially around the caudal aspect of the root of the superior articular process to enter the multifidus muscle.


     Image   Intermediate and lateral branches arise from the dorsal ramus at the same point as the medial branch.


     Image   The medial branch finally crosses the vertebral lamina where it divides into multiple branches that supply the multifidus muscle, the intraspinous ligament and muscle, and ligament and the two facet joints.


     Image   The medial branch of the L5 dorsal ramus has a different course and distribution than those of the L1-L4 dorsal rami. Instead of crossing a transverse process, the L5 dorsal ramus crosses the ala of the sacrum.


     Image   The L5 dorsal ramus is much longer than the typical lumbar levels.


     Image   From the L5-S1 intervertebral foramen, the medial branch of the L5 dorsal ramus runs along the groove by the junction of the ala and the root of the superior articular process of the sacrum before hooking medially around the base of the lumbosacral facet joint (Figure 23-2D).


Thoracic Spine (Figure 23-3)


•   Facet joints


     Image   The thoracic spine has unique features that differentiate it from the lumbar spine.


     Image   Each thoracic vertebra is distinguished by costal facets on the side of the body, and all but the last 2 or 3 segments by articular facets on the transverse process, articulating respectively with the heads and tubercles of the ribs.


     Image   The laminae are short, thick, broad, and overlap each other like roof tiles from above downward.


     Image   The typical spinous process slants posteriorly and downward overlapping between T5 and T8 and being less oblique above and below this level.


     Image   Projecting upward at the junction of the lamina and pedicles are the superior articular processes facing backward, upward, and laterally.


     Image   The articular processes of adjoining thoracic vertebrae form synovial joints, which permit a limited degree of movement, primarily facilitating axial rotation.


     Image   The primary axis of rotation for the mid-thoracic segments is located close to the anterior region of the thoracic intervertebral disk.


     Image   The lower thoracic zygapophysial joints (facets) provide specialized features with the characteristics of this region. There is greater developmental of the mamillary processes, which originate as extension of the superior articular process.


     Image   The mamillary process provides attachment for the multifidus muscle as it covers this medially to attach onto the spinous process of the segments above.


     Image   Small intra-articular synovial folds may be found within the thoracic facet joints. Intra-articular synovial folds originate medially from tissues adjacent to the ligamentum flavum and extend varying distances into the medial joint cavity filling spaces within the joint with fibrofatty tissue.


     Image   The articular surface of the thoracic facet joint is inclined to 60 degrees from the horizontal to the frontal plane and rotated 20 degrees from the frontal to the sagittal plane in a medial direction.


     Image   The lateral aspect of the thoracic joint is placed anterior and the medial aspect of the joint is placed posterior.


     Image   The superior articular facet from the inferior vertebrae is almost flat and faces posterior, superior, and slightly lateral.


     Image   The inferior articular facet is oriented in a reciprocal manner. There is variation in the inclination of the joints by region with the mid-thoracic level approximately 60 degrees off the horizontal plane while the upper segment has a more vertical orientation.


     Image   In contrast to the lumbar spine, the superior and inferior articular processes of the thoracic spine cannot be identified separately because the joints are mostly in the frontal plane and do not face sideward.


     Image   The articular pillar is wider in the thoracic level, and it extends further laterally in relation to the vertebral bodies.


     Image   The articular facets are covered by articular cartilage, and the synovial membrane bridges the margins of the articular cartilage of the 2 facets in each joints.


     Image   Fluoroscopic visualization is more difficult.


     Image   There is no fibrous capsule on the ventral aspect of the joint. Within interspace, the ligamentum flavum is in direct contact with the synovial membrane.


•   Innervation of the thoracic facet joints (Figure 23-2C)


     Image   The thoracic facet joints receive bisegmental innervations from the medial branch of the dorsal ramus of the upper segment and one more cephalad level.


     Image   The medial branches of the thoracic dorsal rami were found to have a reasonably constant course except at mid-thoracic level (T5-T8).


     Image   The medial branches of the thoracic dorsal rami at mid-thoracic levels do not run on bone. Instead, they are suspended in the intertransverse space.


     Image   Thoracic medial branches are not that close to the facet joint as they swing laterally to circumvent the multifidus muscle.


     Image   The dorsal ramus is separated from the ventral ramus (that is, the intercostal nerves) by the anterior part of the superior costotransverse ligament.


     Image   In the thoracic region, the dorsal ramus is short, common trunk of 3 mm to 5 mm, which bifurcates immediately dorsal to the superior costotransverse ligament into a medial and lateral branch.


     Image   The medial branches supply the adjacent intrinsic muscles of the back, the facet joints and skin in the upper thoracic region; the lateral branches supply intrinsic muscles, costotransverse joint, and the skin in the lower thoracic spine.


     Image   Spinous processes of T1-T3 and T11-T12 are located approximately at the level of the facet joint of adjoining level and the one below; T2 spinous process relates to T2-T3 facet joint level.


     Image   Spinous processes T4-T10 are located halfway between the adjacent facet joints and the joints below.


Cervical Spine (Figure 23-4)


Image


Figure 23-4. Cervical spine and facets.


•   Cervical facet joints from C2-C3 to C7-T1


     Image   The atlanto-occipital and the atlanto-axial synovial joints are also present in the cervical spine as two paired joints, but are not considered to be facet joints as they are anterior rather than posterior spinal structures. (See Chapters 14 and 15.)


     Image   The cervical facet joints are formed by the inferior articular process of the superior vertebral segment and the superior articular process of the inferior vertebral segment.


     Image   The superior aspect of the facet joint faces forward and downward at 45 degrees, whereas the inferior aspect of the facet joint faces backward and upward at 45 degrees.


     Image   The facet joints in the cervical spine form paired vertebral column or “pillar” which together with a discovertebral unit provides the 3-prong structural support for this cervical segment.


     Image   The obliquity of the facet joints allows degrees of flexion, extension, and rotation.


     Image   The articular facets are covered by articular cartilage, and a synovial membrane bridges the margins of the articular cartilage of the 2 facets in each joint.


     Image   The cervical facet joints may contain a variety of intra-articular inclusions with fibroid-exposed meniscoid being the most common inclusions.


     Image   The average joint volume is >1 mL.


•   Innervation (Figure 23-2A, B, E)


     Image   The cervical facet joints are well innervated by the medial branches of the dorsal rami. The fibrous joint capsule is richly innervated with mechanoreceptors as well as nociceptive receptors.


     Image   The innervation of the atlanto-occipital and atlanto-axial joints is derived from C1 and C2 root, respectively.


     Image   Cervical facet joints below C2-C3 are supplied by the medial branches of the cervical dorsal rami above and below the joint.


     Image   The C2-C3 joint is also supplied by the third occipital nerve.


     Image   Each C3-C7 dorsal ramus crosses the same segments, transverse process, and divides into lateral and medial branches.


     Image   The medial branch crosses around the waist of the articular processes of the same numbered vertebra.


     Image   The medial branches are bound by fascia, held against the articular pillar and covered by the tendinous slips of the origin of the semispinalis capitis.


     Image   Articular branches arise as the nerve approaches the posterior aspect of the articular pillar within ascending branch innervating the joint above and a descending branch innervating the joint below.


     Image   At C7, in contrast to C3-C6, the medial branches are located at the higher level due to the transverse process. At C7, the base of the transverse process occupies most of the lateral aspect of the articular pillar pushing the medial branch higher.


     Image   The course of the C4 and C5 medial branch nerves has been shown to be relatively constant crossing the waist of the respective articular pillars.


     

Only gold members can continue reading. Log In or Register to continue

Feb 12, 2017 | Posted by in PAIN MEDICINE | Comments Off on Facet Joint Interventions: Intra-Articular Injections, Medial Branch Blocks, and Radiofrequency Ablations

Full access? Get Clinical Tree

Get Clinical Tree app for offline access