Ibrahim Yegül MD Ege University School of Medicine, Izmir, Turkey Cordotomy has been used for a long time for different types of pain. While being extremely effective in relieving pain due to peripheral somatic causes, it does not provide adequate relief in painful dysesthetic or deafferentation syndromes such as post-herpetic neuralgia, phantom limb pain or brachial plexus avulsion. Percutaneous cordotomy is a procedure in which the spinal anterolateral ascending system for the transmission of nociception, known as the spinothalamic tract, is interrupted to relieve pain [1]. It is generally accepted that pain fibers coming from the lower body are located at the mediolateral aspect of the spinal cord while those coming from the upper body are located anteromedially [2] (Figure 58.1). The patient is placed in the supine position on the CT table and the head is immobilized with a tape. It is important to place a small pillow under the patient’s neck for both the patient’s and interventionalist’s comfort (Figure 58.2). The entry point is prepped and draped in the usual sterile fashion. Care is taken not to cover the patient’s face (Figure 58.3). After infiltrating the skin between the first and the second cervical vertebrae, a 20G Crawford needle is introduced on the contralateral side to the pain under CT guidance. After the needle is advanced a few centimeters, a lateral scout view followed by axial images are obtained to check the depth and direction of the needle (Figure 58.4a–c). After confirming correct direction and depth, the needle is advanced. If the needle is directed too anteriorly, blood would be visualized in the needle as the anterior epidural region has rich vascularity. Also, it is not appropriate to direct the needle dorsally. After the needle passes the dura, the flow of cerebrospinal fluid (CSF) is observed (Figure 58.5). Ten milliliters of contrast medium, which consists of 7 ml iohexol (Omnipaque 350 mg/ml) and 3 ml normal saline, is injected into the subarachnoid space of the spinal canal to visualize the spinal cord (Figure 58.6a,b). Under CT guidance, the needle is positioned so that its tip is directed to the anterior portion of the spinal cord. An insulated electrode (Minta® Disposable RF Cordotomy Electrode, 2 mm active tip) is inserted through the needle to enter the spinal cord (Figure 58.7a–d). The electrode tip is stimulated with 2 Hz and 100 Hz current. The patients are questioned about sensory changes and observed for motor twitching during stimulation. When the patient feels the stimulation in the same location as their pain, the procedure to form the lesion can be started. A thermocouple monitored lesion is made using a temperature of 80° C, 10 seconds followed by 20 and 30 seconds (Figure 58.8).
58
Complications of Percutaneous Cordotomy
Introduction
Anatomy
Indications
Contraindications
Technique